(Part Number: NTCBBP000503) – Cable Belt For Condux Deluxe Gs 400 Blower Center 50mm X 260mm – Cable Blowing – Cable Blowing Accessories – Gulfstream 400 Replacement Parts – Condux International

Description

This is the main Cable Drive Belt Assembly for the Condux Gulfstream 400 Fiber Optic Cable Blower. A total of two are used with each blower for the upper and lower drive assemblies. It is recommended to clean and check the tension of your drive belt daily. More information on belt inspection and maintenance is below.

Track Cleaning and Tightening

1. Inspect track before and after each use.
2. Clean after each use, or when necessary. Remove the top assembly to clean thoroughly by:
3. Remove top capscrew with a 3 mm allen wrench and the flat washer on clamp adjustment screw. This will allow for the top track assembly to be unscrewed off the blower with the clamp adjustment.
4. Pressure wash if necessary

To compensate for normal belt stretching, there is a rubber dampening bushing part number 08780028, which is lobed larger on one side than the other, located at the pivot position of the idler skid part number 08780105. It is in the smaller lobe position when it leaves the factory. If a tighter belt is needed, rotate the bushing so the skid presses against the larger lobe. Be sure to have both bushings in the same configuration before locking the skid back into position. If this is not enough, then new tracks must be purchased

Replacement of the Drive Belt

The drive belt needs to be replaced when the machine is unable to tractor drive the specified range of cable diameters. Only genuine spares should be used otherwise the machine may be unsafe and void warranty.

1. Remove the 2 capscrews which hold the sled in place with a 3 mm T-handled allen wrench. This should allow the sled to rotate up.
2. Remove the pivot shaft with an 8 mm allen wrench.
3. On the bottom drive, remove the 3 capscrews from the prox cover with a 2 mm allen wrench.
4. The bearing cap can be removed from both the top and bottom assembly using a 5 mm allen wrench.
5. At this point, the drive pulley can be removed straight out the same hole as the bearing cap and the belt can be removed. This sequence is reversed for the reassembly of the new belt with a key note, the dampening bushing must be rotated back to the smaller lobe position on the pivot shaft.

NOTE: Become familiar with the Replacement and Wear Parts. Contact us for a copy of the manual.

Cable Diameter Range [in]:
0.157-1.125

Cable Diameter Range [mm]:
4.0-28.6

Height [in]:
10

Length [in]:
10

Packaging Type:
Boxes

Width [in]:
10

Shipping Method:
Parcel

Unit of Measure:
EA.

Units Per Package:
1

Weight [lb]:
10.000000